EN AW-6060 (AlMgSi) is the same material your supplier may list as 6063 or JIS A6063. This page maps the designations across standards and gives the ISO N-group machining starting point, brand-neutral.
| System | Designation |
|---|---|
| EN (EU) | EN AW-6060 (AlMgSi) |
| Werkstoffnummer | 3.3206 |
| AISI / ASTM / UNS (US) | 6063 (nearest) |
| JIS (Japan) | A6063 (nearest) |
Compiled from the public standard designation systems (EN 10027, SAE/AISI, ASTM, UNS, JIS). Entries marked “nearest” are the closest commonly-cited counterpart, not a drop-in equivalent. Always verify against the material certificate.
At least one designation on this page is a nearest commonly-cited counterpart rather than a same-composition equivalent (structural and cast grades are specified by properties, not chemistry). Confirm suitability against the material certificate and the drawing requirement, not this table alone.
The profile-extrusion alloy: softer and gummier than 6082, prone to smearing in T4. In T6 it cuts cleanly at very high speed with sharp polished tools.
| ISO group | Starting Vc (coated carbide, turning) | Feed fn |
|---|---|---|
| N N · Non-ferrous | 300–1200+ m/min · 985–3940+ sfm | 0.05–0.3 mm/rev · .002–.012 ipr |
Group-level starting range from our speeds & feeds guide; convert to RPM with the speeds & feeds calculator. Condition, subgroup and operation shift the number — the material page has the detail: ISO N · Aluminium (extrusion).
Related materials: EN AW-2024 / AlCu4Mg1 · EN AW-5083 / AlMg4.5Mn · EN AW-6061 / AlMg1SiCu · EN AW-6082 / AlSi1MgMn · EN AW-7075 / AlZn5.5MgCu · EN AW-5754 / AlMg3
Are you overpaying on the inserts you run in EN AW-6060 (AlMgSi)? Paste your insert list and get a cost audit in about 30 seconds: cross-brand equivalents at the same ISO application position, and where you are likely overpaying. No signup, no sales call.
EN AW-6060 (AlMgSi) (Werkstoffnummer 3.3206) corresponds to 6063 (nearest) as the nearest commonly-cited counterpart — check the certificate before substituting. In JIS terms the counterpart is A6063 (nearest).
It is an ISO N-group material, so the starting window is 300–1200+ m/min · 985–3940+ sfm at 0.05–0.3 mm/rev · .002–.012 ipr for coated-carbide turning, adjusted for condition and operation. For a grounded, brand-neutral pick — grade, geometry and cutting data across 13 brands — ask the advisor.
Not automatically: this pairing is nearest-by-properties, and structural or cast grades are specified by mechanical requirements. The drawing standard and the material certificate decide, not the cross-reference table.
Knowing the material is half the job; picking the grade and cutting data for the operation is the other half. That is what the advisor does, grounded in catalog data and honest when there is no verified match.