Carbide grade · Seco · ISO P
Seco TP1000
TP1000 is a Seco carbide insert grade, applied in the ISO P area. Its ISO position comes from the manufacturer grade comparison charts in this reference. 1 Direct peer is from other makers, listed in the same row of a manufacturer comparison chart. This is chart comparability, not verified cutting performance. 75 more grades share an ISO position only and are not verified. Same position is not the same performance: verify on a sample part before switching.
Grade summary
- Brand
- Seco
- ISO application area
- P — steel
- ISO position (manufacturer charts)
- P10
Cross-brand alternatives (manufacturer charts)
Direct peers
Listed in the same row of a manufacturer comparison chart. This is chart comparability, not verified cutting performance.
- Sandvik GC4315 ISO P10 · 2 charts (Ingersoll, Tungaloy)
Same ISO position, not verified
These grades overlap in ISO position only. No manufacturer chart lists them together, and operation and tool material are not verified.
- Kyocera PV710 ISO P10 · not verified · cermet
- Mitsubishi MS6015 ISO P10 · not verified
- Kennametal KC515M ISO P10 · not verified
- Kennametal KC9110 ISO P10 · not verified
- Kennametal KCU10 ISO P10 · not verified
70 more not shown.
The best-evidenced alternative to Seco TP1000 from another maker, with published cutting speeds (sourced, and compared only where both makers publish them for the same conditions), coating and what would decide a switch. Usually in your inbox within 30 minutes.
Check Seco TP1000 against the published chart evidence first. If this grade has a documented candidate, you can order an automatically generated report for one grade (about US$10, charged EUR 9), or add up to two grades (about US$24, charged EUR 22). Currency conversion and tax at checkout may change the USD amount. A chart comparison is not a guaranteed substitute.
Check this grade and see the report →Compare TP1000 side by side
Frequently asked questions
What is Seco TP1000?
TP1000 is a Seco carbide insert grade, applied in the ISO P area, as positioned in manufacturer grade charts.
Which grades are direct peers of TP1000?
1 grade from another maker is listed in the same row of a manufacturer comparison chart as TP1000: Sandvik GC4315. This is chart comparability, not verified cutting performance. Grades that share only the ISO position are listed separately as not verified. Same position is not the same performance: verify on a sample part before switching.
Does this cross-reference favour specific brands?
No. Comparable grades appear here only because manufacturer-published comparison charts place them at the same ISO application position. No manufacturer pays for placement, nothing on this page is sponsored, and CuttingToolsAI sells no tools and earns no commission. Placements backed by a single chart are flagged as such, and every comparison ends the same way: verify on a sample part before switching.
Grade charts by brand
Are you overpaying on your TP1000 inserts? Paste your insert list and get a cost audit in about 30 seconds: cross-brand candidate alternatives at the same ISO application position, and where you are likely overpaying. No signup, no sales call.
After the free check: a sourced PDF + XLSX report from EUR 9 for one grade. How buying works
Related grades
Where TP1000 is used: designations and materials