Carbide grade · Walter · ISO K
Walter WAK20
WAK20 is a Walter carbide insert grade (Coated), applied in the ISO K area. Its ISO position comes from the manufacturer grade comparison charts in this reference. 1 Direct peer is from other makers, listed in the same row of a manufacturer comparison chart. This is chart comparability, not verified cutting performance. 82 more grades share an ISO position only and are not verified. Same position is not the same performance: verify on a sample part before switching.
Grade summary
- Brand
- Walter
- Coating / substrate
- Coated
- ISO application area
- K — cast iron
- ISO position (manufacturer charts)
- K15 · K20
Cross-brand alternatives (manufacturer charts)
Direct peers
Listed in the same row of a manufacturer comparison chart. This is chart comparability, not verified cutting performance.
- Sandvik GC3210 ISO K15 · 2 charts (Ingersoll, TaeguTec)
Same ISO position, not verified
These grades overlap in ISO position only. No manufacturer chart lists them together, and operation and tool material are not verified.
- ISCAR IC908 ISO K20 · not verified
- Kennametal KCK20B ISO K20 · not verified
- Mitsubishi MC5015 ISO K15 K20 · not verified
- Mitsubishi UC5115 ISO K15 K20 · not verified
- Sumitomo AC4015K ISO K15 K20 · not verified
66 more not shown.
Tougher alternatives
Positioned above this grade on the ISO scale (more toughness, less wear resistance). ISO position only, not verified.
- Mitsubishi VP15TF ISO K20 · not verified · carbide
- Mitsubishi VP20RT ISO K20 · not verified
- Kennametal KC524M ISO K20 · not verified
- Mitsubishi UTi20T ISO K20 · not verified
- Kyocera PR1510 ISO K20 · not verified
6 more not shown.
The best-evidenced alternative to Walter WAK20 from another maker, with published cutting speeds (sourced, and compared only where both makers publish them for the same conditions), coating and what would decide a switch. Usually in your inbox within 30 minutes.
Check Walter WAK20 against the published chart evidence first. If this grade has a documented candidate, you can order an automatically generated report for one grade (about US$10, charged EUR 9), or add up to two grades (about US$24, charged EUR 22). Currency conversion and tax at checkout may change the USD amount. A chart comparison is not a guaranteed substitute.
Check this grade and see the report →Compare WAK20 side by side
Frequently asked questions
What is Walter WAK20?
WAK20 is a Walter carbide insert grade (Coated), applied in the ISO K area, as positioned in manufacturer grade charts.
Which grades are direct peers of WAK20?
1 grade from another maker is listed in the same row of a manufacturer comparison chart as WAK20: Sandvik GC3210. This is chart comparability, not verified cutting performance. Grades that share only the ISO position are listed separately as not verified. Same position is not the same performance: verify on a sample part before switching.
Does this cross-reference favour specific brands?
No. Comparable grades appear here only because manufacturer-published comparison charts place them at the same ISO application position. No manufacturer pays for placement, nothing on this page is sponsored, and CuttingToolsAI sells no tools and earns no commission. Placements backed by a single chart are flagged as such, and every comparison ends the same way: verify on a sample part before switching.
Grade charts by brand
Are you overpaying on your WAK20 inserts? Paste your insert list and get a cost audit in about 30 seconds: cross-brand candidate alternatives at the same ISO application position, and where you are likely overpaying. No signup, no sales call.
After the free check: a sourced PDF + XLSX report from EUR 9 for one grade. How buying works
Related grades
Where WAK20 is used: designations and materials