Carbide grade · Tungaloy · ISO N
Tungaloy T1010
T1010 is a Tungaloy carbide insert grade (Uncoated), applied in the ISO N area. In this cross-reference it appears on 4 insert designations; the same insert geometry is also made by ISCAR, Kennametal, Sandvik, Seco, Walter. No reference-grade record exists for this designation. Same position is not the same performance: verify on a sample part before switching.
Grade summary
- Brand
- Tungaloy
- Coating / substrate
- Uncoated
- ISO application area
- N — non-ferrous (aluminium, copper)
- Application range (catalog)
- N01–N10
- Used in
- 4 insert designations in this reference
Cross-brand equivalents (manufacturer charts)
No reference-grade record exists for this designation.
Same insert geometry, other brands
These makers produce the same insert designation in their own grade. Shared geometry is not a grade equivalence.
| Brand | Grade | Coating | Shared designations |
|---|---|---|---|
| ISCAR | IC28 | Uncoated carbide | CCGT09T304, DCGT11T304, TCGT16T304, VCGT160404 |
| Kennametal | KCU25 | PVD AlTiN | CCGT09T304, DCGT11T304, TCGT16T304, VCGT160404 |
| Sandvik | H13A | Uncoated carbide | CCGT09T304, DCGT11T304, TCGT16T304, VCGT160404 |
| Seco | H15F | Uncoated fine-grain carbide | VCGT160404 |
| Walter | WNK10 | Uncoated sharp | CCGT09T304, DCGT11T304, TCGT16T304, VCGT160404 |
Insert designations using T1010
| Designation | Geometry | Catalog code | Application |
|---|---|---|---|
| CCGT09T304 | 80° Diamond · 7° clearance · 0.4mm Rε · aluminium geometry | CCGT09T304-AL T1010 | N01–N10 |
| DCGT11T304 | 55° Diamond · 7° clearance · 0.4mm Rε · positive aluminium | DCGT11T304-AL T1010 | N01–N10 |
| TCGT16T304 | 60° Triangle · 7° clearance · 0.4mm Rε · aluminium geometry | TCGT16T304-AL T1010 | N01–N10 |
| VCGT160404 | 35° Rhombic · 7° clearance · 0.4mm Rε · positive aluminium | VCGT160404-AL T1010 | N01–N10 |
Frequently asked questions
What is Tungaloy T1010?
T1010 is a Tungaloy carbide insert grade (Uncoated), applied in the ISO N area, used in 4 insert designations in this reference.
Does this cross-reference favour specific brands?
No. Comparable grades appear here only because manufacturer-published comparison charts place them at the same ISO application position. No manufacturer pays for placement, nothing on this page is sponsored, and CuttingToolsAI sells no tools and earns no commission. Placements backed by a single chart are flagged as such, and every comparison ends the same way: verify on a sample part before switching.
Grade charts by brand
Are you overpaying on your T1010 inserts? Paste your insert list and get a cost audit in about 30 seconds: cross-brand equivalents at the same ISO application position, and where you are likely overpaying. No signup, no sales call.
Related grades